Another Day In The Life, Part 1

So, I decided to renovate the lawn.  That means cutting the grass down to 1",  aerating the lawn, collecting all the grass-clippings so that new seed can reach the ground and get some sunlight, and watering the lawn slightly 2x a day to keep the seeds moist.

I thought I had the timing perfect.  Aerate the lawn with my core aerator (pulls 3"x1/4" plugs of soil out of the ground and deposits them on the surface.  That allows air and water and fertilizer to get deep into the soil, and reduces compaction.

And since I was going to be dragging the aerator across the lawn with the riding mower, I would mow the grass short in a pattern that threw the grass clippings into just a couple of 4" wide rows.

Then I would rake the grass up and save it for the compost pile.  Then spread the grass seed.  The weather forecast was for occasional rain for the next week.  Perfect for the seeds to germinate in 80 degree temps.

Well, that was the PLAN...

The aerator has a tray on the top for putting heavy stuff on the top to make the aerator tubes sink deeply. 

I bought solid cinder blocks for it years ago.  And I added more weight this time (the ground was a bit dry).

No plan works...  As soon as I started (1 pm Wednesday), I discovered the aerator tires were flat and one was tire was off the wheel.  I had to take all the heavy stuff off and raise the end of the aerator off the ground supported by bricks.  Taking off the tire was awkward.  There was one bolt on the outside and 2 on the inside.  Only the farthest inside bolt held by a wrench allowed the outside bolt to be loosened.  With the wheel off, I had to reinflate the tire.

Of COURSE it didn't have a tube inside.  That would have been too easy.  I had to get the tire re-seated onto the metal wheel in order to get any air to stay in it.  I know from past experience that pressure on the outside of the tire can get the tire re-seated onto the wheel.  I spent an hour struggling to do that, to no avail.  Well, I worked at a tire company briefly, and I remembered they had an air-pressurized tube that went around small tires to press the tire to the wheel.  I don't have one of those.  I was dripping with sweat and worn out, so I stopped for an hour.  Drank 3 glasses of water.

When I was cooled down, I tried to think of ways to squeeze the tire onto the wheel.  I have an air pump to add a lot of air through the valve all at once.  With that attached to the valve, I tried twisting a rope around it, and I tried turning a loop of rope with a crowbar.  That didn't work.  I tried putting the tire in my bench vise and using some wood clamps across the tire in 3 directions.  That didn't work.

Damn!  I finally thought of ratcheting straps (like you use to hold a boat to a trailer.  That was awkward.  12' of strap around a 8" tire takes a lot of winding.  And the straps I had only get to 6' short (from 12').  I finally managed to hook the end of the strap at a point where the ratchet would really tighten.

It didn't work.  Well, not the 1st time or the 2nd or the 3rd or 4th.    But eventually, by pounding the sides of the tire with a rubber mallet, the seal finally caught suddenly!  YAY, HOORAY, and HALALULEAH!!!  It caught suddenly and filled...  I couldn't find anything on the tire that said what PSI to fill it, but I went for 12 as that seemed tight but with a slight "give".

So I brought it back outside and put the wheel back on the axle.  Being a sensible type, I also  checked the other tire.  It was at "0" but the bead to the wheel had not broken.  So I dragged the air pump outside and filled it to 12 psi too.

By that time it was 5 pm.  I decided to stop for the day and make dinner.

Thursday, I went all around the yard, aerating and mowing at the same time (very slowly so the aerator tubes could sink into the soil).  Just before I was done, the mower ran out of gas.  Well, I had more gas in the can, so I refilled it.  And then the mower wouldn't start again! 

OK, I guess I put a lot of stress on the riding mower hauling the aerator around with all that weight on it.  But why the mower wouldn't start was confusing.  I'm barely competent with gas engines.  I thought maybe I flooded the carburator.  I decided to stop for the day and I covered the mower with a tarp due to the possibility of rain.

And the next day is tomorrow's post...